| ¡@
|
| Features: |
| ¡@ |
1. High quality translucent vinyl
2. Easy installation
3. Sweet looking
4. Removable |
| Specification: |
| ¡@ |
About 20cm in diameter |
| ¡@ |
|
 |
| Installation: |
| ¡@ |
1. Remove your case window, figure out where to place the etching, once the correct spot determined, flip the window over to the other side.
2. Clean the window completely using soap and water or Lucite Cleaner then dry it, spray a fine mist of water over the window surface.
3. Peal the opaque backing off the translucent backing, make sure the appliqué stays on the translucent backing.
4. Apply the appliqué to the window carefully, use a masking tape as a helpful guideline to position it properly, the appliqué shall face inside the PC case.
5. Remove translucent backing from the appliqué.
6. Squeeze out any trapped air bubbles with a plastic card, after 24 hours, if still some, using a needle, poke a hole in the middle of each air bubble and squeeze out again. The etched effect improves as the adhesive dries. |
|
|
| Application: |
|
| ¡@ |
|
|
|
